S9 Climateline MAX Oxy Hose Tubing w/ O2 Port by ResMed

S9 Climateline MAX Oxy Hose Tubing w/ O2 Port by ResMed
Brand: ResMed
Product Code: RM36996
Availability: In Stock

Available Options


* ADD CPAP Pillow for Only £45.00:

Qty: Add to Cart

The ClimateLine™ Max Oxy Air Tubing with Supplemental Oxygen Port for S9 Machines is a 19mm inner diameter, heated tubing with a port to add oxygen to the air stream.
It is for use ONLY with a ResMed S9 Series machine using an H5i Heated Humidifier.
The ClimateLine tubing uses a sensor that measures humidity to maintain a uniform temperature from the machine all the way to the mask.
The temperature in the tube itself is warmed by a thin copper wire on the outside of the tube.
The ClimateLine™ Max Oxy Air Tubing with Supplemental Oxygen Port a 19mm tubing and can easily support higher pressures, such as though frequently found in BiLevel therapy.


  • Hose


  • Hose Length: 75 inches
  • Hose Inner Diameter: 19mm
  • Maximum Pressure: 30 cmH3O
  • Hose Material: Polyethylene & Electrical Components
  • Latex and Silicone Free

Cleaning Instructions

  • Daily = Disconnect from machine and hang to dry.
  • Weekly = Disconnect, using a mild soap wash in warm water. Rinse well and hang to air dry.
  • Do not hang in direct sunlight.
  • The tube may be immersed in water but must be completely dried before use.

ClimateLine Tubing Information and Use:

  • Tubing Options: ResMed's S9 Line of machines has a number of tubing options. The SlimLine 15mm tube is a non-heated tube in a thin, flexible style. The machine can also be used with an OPTIONAL heated ClimateLine Tubing which integrates with the machine and OPTIONAL H5i Heated Humidifier to provide increased humidification and reduced chances of rainout. The ClimateLine is available in two diameters. The SlimLine 15mm ClimateLine Tubing and a standard diameter 19mm ClimateLine Max Tubing. Additionally a standard diameter, non-heated tube may be used.
  • ClimateLine Tubing Lengths: A traditional CPAP tube is 72 inches long. The optional 15mm ClimateLine Tubing length is 78 inches. The optional 19mm ClimateLine MAX Tubing length is 75 inches.
  • Installation of the ClimateLine: The ClimateLine attaches to the back of the machine using the same port as a standard hose. The electronics connection is below the port and may be covered with a protective flexible rubber cap attached the machine. Place the machine so the back of the unit housing the filter and hose connection is facing you. After removing the rubber cap, orient the hose so the electronic tab is facing toward the filter. Push the tubing end firmly onto the port, then rotate the tube clockwise to fit the two electronic connections together.
  • Removing the ClimateLine: To remove the ClimateLine from the back of the machine, rotate the hose counter clockwise. The electronic connections disengage allowing the hose to removed. Cover the machine's electronic port with the flexible rubber cap to protect the connections.

Cleaning Instructions for the ClimateLine Heated Tube:


  • Disconnect the tubing from the machine and mask.
  • Hang in air dry.
  • Do not hang the tubing in direct sunlight.


  • Disconnect the tubing from the machine and mask.
  • Wash the tubing with warm water and a mild detergent.
  • Rinse thoroughly with clean running water.
  • Hang and allow to air dry out of direct sunlight.
  • The tubing can be fully immersed in water but MUST BE completely dry before use.

There are no reviews for this product.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: